Knowledge Base Articles
Browse Results: ICX 7250 > Known Issues and Workarounds
-
ICX 7250 7450 PoE port flap on 08.0.30f and above (TSB 2017-264 [A])
The user may experience port flaps on ICX7250 & ICX7450 in a corner case scenario. If ‘inline power non-pd-detection enable’ command is configured, the flaps are seen. -
What are the cables needed for ICX7250, ICX7450, ICX7750 Console Access?
Description of the different cables needed in order to access via console the ICX7250, ICX7450, ICX7750 devices using a USB port -
7250 ports connected to 7450 do not come up when 7250 reloaded.
-
Error message after upgrade - Optics <-> Speed mismatch, replace with SFP optic
After upgrade to 8.0.30k and reboot started seeing error message via console -
TFTP received error request -- code 1 message File not found
TFTP received error request -- code 1 message File not found -
Front panel tab for ICX7250-48 GUI incorrectly displays as 7240
Front panel tab for ICX7250-48 GUI incorrectly displays as 7240 -
DHCP snooping table and IPSG not in sync when client moves to another port of the switch
When user gets connected to 1st AP (on 1st switchport) and moves to 2nd AP (on 2nd switchport), then the MAC entry does not get cleared from IP Source guard table of 1st port. -
FastIron on 8060 or newer are not passing EAPOL broadcasts
8.0.60 or above is blocking the EAPOL broadcast addresses from switching no matter which media or ports/plans we use. It clearly works in 8.0.30 or below as shown by the packet captures. Please let us know if anything else is needed. -
10G-SFPP-TX-A Transceiver consumes significantly more power than typical 10G SFPs (TSB 2019-002-E)
This bulletin provides guidelines for deploying 10G-SFPP-TX-A within the power capabilities of the supported ICX switches. -
PoE port flaps for a period of time after a stack reload
PoE ports keep flapping during a period of time from some minutes up to an hour after a stack reload.