Knowledge Base Articles
Browse Results: vSZ Dataplane
-
How can i change the hostname of vSZ-D ?
You can use a CLI command to change the hostname of vSZ-D. -
vDP HW config using direct IO for better throughput and performance
-
How to perform packet capture in VDP CLI for a specific Client?
It is advisable to perform packet capture on a specific client instead of using "ALL" as an option, since it will degrade the VDP performance. -
vSZ/SZ running on versions 5.1.1.0.589, 5.1.1.0.496 shows incorrect guest pass expiration time on default guest print page and in the E-mail sent to the user.
-
10GB vDP license requires 1GB license to function
Customer has valid 10GB vDP licenses. 90 day temporary license expires and all dataplanes were in "Pending" state. When Customer attempted to sync the licenses, the following error appeared ""Unable to approve the data plane. Reason: Insufficient vSZ-D Capacity License, please purchase license... -
Why vDP shows CPU utilization higher than normal.
This article explains CPU utilization is seen higher than normal on vDP -
Poor performance of vDP tunnel on a site with 4G MPLS connection
Getting 48 Mbit up / 10Mbit down on the 4G connection with local breakout. However with GRE enabled WLAN the throughput was in kbps. -
This article gives information on how to upgrade the vDP through GUI
-
How to Upgrade vSZ-D via FTP using Command Line Interface
This article provides information on how to upgrade the vSZ-D through CLI -
How to run packet capture from vSZ-D Command Line Interface
This article explains the procedure of collection Packet Captures from vSZ- D CLI.