Knowledge Base Articles
Browse Results: ZoneFlex Indoor
-
AP's Stuck in Provisioning Loop
Connecting an AP from a remote location and placing the AP on a different Management VLAN than what the ZD is on. The AP discovers the ZD and is stuck in a provisioning loop. -
Customer wants to know why AP chooses the same bad channel when background scanning is enabled
Explaining on why AP will use all channels when background scanning is enabled. -
Maximum WLAN count on ZD AP.
Max amount of WLAN's that can be used on an AP controlled by ZD. -
Commands for verifying CP and DP connections from APs via the SCG/vSZ/SZ CLI. This method will work regardless of AP reach-ability via SSH.
-
AP status shows as rejected state
Why does my AP show up as rejected in the webgui? -
Mesh nodes don't see each other, only see root node why?
Mesh nodes don't see each other, only see root node why? -
When you run a speed flex between ZD/AP; and you encounter any drop in packets. This details will give you a start to look at the problem.
-
Connecting both the Ethernet ports of the AP to switch causes switching loops
Connecting both the Ethernet ports of the AP to switch increases the broadcast storm in the switched network. -
MIB reference request. This can be found in the customer web portal or through this note.
-
Zebra GX420T printers fail to connect to the WLAN with WPA2/WPA(Mixed/AES) but works with OPEN and WEP?