Knowledge Base Articles
Browse Results: virtual SmartCell Gateway > Configuration
-
How to retrieve Access Point board information?
How to retrieve Access Point board information -
Setting AP's Ethernet port to operate at 100 or 10 Mbps full duplex
This article discusses command line options to manually set the AP's Ethernet port at 100 Mbps or 10 Mbps speed -
APs supported on vSCG release version 2.5.0.1.174
This article provides information on the AP models that are supported on vSCG with version 2.5.0.1.174 -
Wired client to a Mesh Access Point.
Wired client to a Mesh Access Point -
Seeing client disconnects after enabling ChannelFly
Seeing client disconnects after enabling ChannelFly -
DNS name resolution for IP address of SCG or vSCG
This articles shares the domain name which APs resolve to discover the SZ/vSZ controller -
SmartZone Ports to be open on a Firewall w/NAT
What ports/protocols need to be open to permit AP to SmartZone controller communication, and if including NAT? -
Does vSCG / SCG supports IPv6 format
vSCG / SCG supports only IPv4 but not IPv6 -
CLI command to move an AP from one zone to another zone in vSCG
This article give you the CLI command to move an AP from one Zone to another Zone.