Knowledge Base Articles
Browse Results: virtual SmartCell Gateway > Performance
-
Ruckus Product Information - DATA SHEETS, FEATURES, CASE STUDIES, WHITE PAPERS, APPLICATION NOTES
Ruckus Product Information - DATA SHEETS, FEATURES, CASE STUDIES, WHITE PAPERS, APPLICATION NOTES -
Running Iperf to cross-check SpeedFlex test results
This article explains how to run Iperf if a customer would like to cross-check SpeedFlex results. -
Best Practices - AP Mesh Networking - Outdoor Guide attached
What are Ruckus Best Practice guidelines for AP Mesh Networking, including Outdoors? -
Why do APs report stuck beacons or high airtime on 2.4G radios?
High interference can cause APs to raise NF and report stuck beacons -
vSZ vSCG CPU Core and Memory increase Limitations
Adding cores to a single node of a 2 node vSCG/vSZ cluster caused the node to stay out of service until both nodes are rebooted. -
R710 AP cannot connect after upgrading controller to SmartZone v3.1.1
AP certificate issues may prevent R710 from connecting to vSZ/SCG/SZ-100, or cause client webauth/guest pass authentication failure. -
DOCSIS, GPON, LRE infrastructure roaming and connectivity issues
Classic switched infrastructure (GPON & DOCSIS in particular) for AP backhaul may not handle Wifi client "fast roaming" well, so use tunneled SSIDs. -
Unable to access the AP via GUI after terminating it on vSZ
This articles gives you the information on why the APs GUI access is disabled when it joins vSZ -
MAC Flap causing APs not to accept new connections
The articles provides one of the possible resolutions to MAC Flap which causes APs not to accept new connections -
SZ: What happens when an AP loses connectivity?
AP Reboot Timeout and Smart Monitor can affect disconnected SmartZone AP behavior.