Knowledge Base Articles
Browse Results: SmartCell Gateway
-
Master KBA: All about AP firmware - Standalone, ZD, or vSCG/SCG/SZ managed
This is a collection of articles on how to configure Access Points for any use. -
vSCG: Although originally pointed with 'set director ip' command, after AP joins vSCG and reboots with factory default, it's server list will become empty.
-
Unable to register ZD-based AP to vSCG 2.x
Early SCG 2.x versions need to enable LWAPP2SCG policy to auto-convert ZD managed APs. -
SCG200: Unable to upgrade SCG past version 2.6
Can't upgrade SCG beyond 2.6 without factory default -
Change system hostname - SCG / vSCG / SZ100
An Scg / vSCG / SZ100 hostname can be modified with CLI commands -
WISPr redirect not working on SCG-200
This article describes common issues which may cause the WISPr redirect to fail on the SCG-200 controller -
How to configure the AP management VLAN on the SCG controller
This article explains how to assign SCG-managed AP traffic to a specific VLAN. -
Channel change too frequent when using channel fly
This article describes how to reduce the frequency between channel changes on SCG APs with channelfly enabled. -
SZ / SCG AP tunnel MTU Configuration location
This article describes where the tunnel MTU setting may be found on SZ / SCG -
F5 VPN Issues from Wi-Fi Network.
This article describes reasons why a VPN may not establish over a wifi network