Knowledge Base Articles
Browse Results: SmartCell Gateway
-
Actions to take in case of DHCP Decline message from the client
This article explains what causes DHCP Decline response from a client, how to diagnose the problem, and what needs to be done to fix the issue. -
Running Iperf to cross-check SpeedFlex test results
This article explains how to run Iperf if a customer would like to cross-check SpeedFlex results. -
How to change interface and DNS IP of vSCG?
Following article explains the steps on how to change the interface IP and DNS on vSCG -
Connecting Access Points to specific Zones in SCG
Using Registration Rules and Provisioning Tags to connect newly joined Access Points to specific Zones in an SCG cluster -
Initial setup of SCG 200 stuck at "bootstrapping"
SCG200 get stuck at the bootstrapping error when running setup via GUI -
Installing and configuring FreeRADIUS on Linux
This article describes the steps required to install and configure a basic FreeRADIUS instance on a Linux-based host (Ubuntu). -
Windows 8.1 clients are asking for proxy server credentials after entering 802.1x credentials
This article explains how to avoid an issue when the windows 8.1 clients ask for proxy credentials after the 802.1x authentication. -
Really bad tput when doing internet tput test
Wireless client is getting in the most part a really bad tput though the configuration is done correctly on the vSCG 3.0.4 SW. Client connects fine and gets 1Mbps or below and then suddenly it would jump to something like 50Mbps and then drop down to 1Mbps. Rate limiting is not enabled. -
SCI - Operational reports do not include SCG data
The customer has recently connected an SCG to an SCI host, however they are not receiving data from the SCG. This article describes how to enable the ap-sci command to have this data collected and submitted to SCI