Knowledge Base Articles
Browse Results: SmartCell Gateway > Configuration
-
How to convert vSCG/SCG APs to Standalone or ZD managed
vSCG/SCG APs: Perform factory default and load new firmware image for Standalone or ZD management use -
Master KBA: All about AP firmware - Standalone, ZD, or vSCG/SCG/SZ managed
This is a collection of articles on how to configure Access Points for any use. -
vSCG: Although originally pointed with 'set director ip' command, after AP joins vSCG and reboots with factory default, it's server list will become empty.
-
Change system hostname - SCG / vSCG / SZ100
An Scg / vSCG / SZ100 hostname can be modified with CLI commands -
How to configure the AP management VLAN on the SCG controller
This article explains how to assign SCG-managed AP traffic to a specific VLAN. -
Channel change too frequent when using channel fly
This article describes how to reduce the frequency between channel changes on SCG APs with channelfly enabled. -
SZ / SCG AP tunnel MTU Configuration location
This article describes where the tunnel MTU setting may be found on SZ / SCG -
Duplicate user IP addressing may cause authentication failures
This article explains that UE IPs should be unique on the SCG controller. There should never be an instance where a UE shares an IP with another (which is common where sites are deployed behind NAT). Distinct prefixes should be used for each site. -
Import Batch Provisioning APs
Import Batch Provisioning APs -
AP Ethernet Port type General
AP Group specific model AP Port Setting types include Access, Trunk, and General that behaves similarly to Trunk