Knowledge Base Articles
Browse Results: SmartCell Gateway > Installation
-
R710 AP cannot connect after upgrading controller to SmartZone v3.1.1
AP certificate issues may prevent R710 from connecting to vSZ/SCG/SZ-100, or cause client webauth/guest pass authentication failure. -
SmartZone 3.2 Upgrade Port Changes
Starting in SZ 3.2 release, AP firmware upgrade is performed using HTTPS port 11443. Earlier releases use HTTP port 91. To ensure that all APs can be upgraded successfully to the new firmware, open both ports 11443 and 91 in the network FW. -
Broadcast storm caused by IPV6 Multicast listener reports
Wireless network becomes unusable and AP's lose heartbeats due to IPv6 multicast listener reports -
SCG/SZ/vSZ Full Wireless Client Isolation
Configuring Full Client Isolation in SCG/SZ/vSZ after version 3.1.1 (below version 5.0) -
Toggle AP LEDs in SZ environment
LEDs are turned off but there are a couple of ways to enable/disable lights on the vSZ controlled APs. -
SmartZone Pre-check Scripts for Data Migration Upgrades
This script extends SZ upgrade process monitor, to allow more time for data migration pre-check. -
SCG/vSCG: How to configure DHCP Option 43 on Mikrotik
Mikrotik: How to configure DHCP Option 43 on Mikrotik -
RuckusGRE port numbers used between AP and SCG in SZ 2.5.0.1.x
The below list provides ports/protocols to support AP to SCG via RuckusGRE tunnel to WAG in 2.5.0.1.x. -
Maximum number of local DB users and guest passes in SZ controllers
Maximum number of local DB users and guest passes in SZ controllers. -
What are the order of steps in SmartZone AP Zone upgrades?
APs exchange information with SmartZone, triggering firmware download, reboot, configuration.