Knowledge Base Articles
Browse Results: SmartCell Gateway > Installation
-
Connecting Access Points to specific Zones in SmartZone or SCG
Using Registration Rules and Provisioning Tags to connect newly joined Access Points to specific Zones in an SmartZone or SCG cluster -
Initial setup of SCG 200 stuck at "bootstrapping"
SCG200 get stuck at the bootstrapping error when running setup via GUI -
We can upgrade multiple vSCG instances in a cluster
-
Really bad tput when doing internet tput test
Wireless client is getting in the most part a really bad tput though the configuration is done correctly on the vSCG 3.0.4 SW. Client connects fine and gets 1Mbps or below and then suddenly it would jump to something like 50Mbps and then drop down to 1Mbps. Rate limiting is not enabled. -
How to convert vSCG/SCG APs to Standalone or ZD managed
vSCG/SCG APs: Perform factory default and load new firmware image for Standalone or ZD management use -
vSCG: Although originally pointed with 'set director ip' command, after AP joins vSCG and reboots with factory default, it's server list will become empty.
-
Unable to register ZD-based AP to vSCG 2.x
Early SCG 2.x versions need to enable LWAPP2SCG policy to auto-convert ZD managed APs. -
SCG200: Unable to upgrade SCG past version 2.6
Can't upgrade SCG beyond 2.6 without factory default -
Change system hostname - SCG / vSCG / SZ100
An Scg / vSCG / SZ100 hostname can be modified with CLI commands -
How to change an SCG clustername in production
This article explains one method for changing the name of an SCG cluster in production. This may be necessary if underscores were used initially and, after upgrading to RuckOS 3.0+ (where underscores are no longer permitted in the cluster name), a new node needs to be joined.