Knowledge Base Articles
Browse Results: SmartCell AP > Configuration
-
Channel change too frequent when using channel fly
This article describes how to reduce the frequency between channel changes on SCG APs with channelfly enabled. -
How do you convert a SmartZone (SCG/SZ-100/vSZ) AP to work with a ZD
-
How to login to SmartZone managed APs?
You can login to SmartZone managed APs directly, with Zone setup field info, or with cluster username password on SCG/vSZ-H APs, or defaults on Staging zone APs. -
Toggle AP LEDs in SZ environment
LEDs are turned off but there are a couple of ways to enable/disable lights on the vSZ controlled APs. -
The best way to setup Mesh APs?
Begin with all your APs connected to the ZD/SZ controller by wire, so they get fully configured first, then detach their Eth cables and deploy where you need them to Mesh from. -
SZ100 Clustering Questions - AP Load Balancing
APs are assigned to Cluster Nodes in a round-robin fashion, data traffic is not 1:1 to AP controller, and you can increase cluster size to increase throughput. -
FAQ: Ruckus AP Device Certificate Refresh
Device certificates on Ruckus APs manufactured prior to January 2016 may require a certificate refresh prior to November 2016 to avoid service interruption. -
SCG/vSZ controlled AP ver 3.4.2 has 5GHz LED off but 5GHz SSID is working
AP controlled by vSZ/SCG running 3.4.2 have 5Ghz LED off while 5Ghz SSID/WLAN is operational. Issue persists until AP is rebooted. This is a cosmetic issue that does not affect operation but impacts direct verification of service on AP via LED state -
SZ Moving Mesh Enabled AP and disabling MESH
How to move a MESH enabled AP to a different Zone and how to disable MESH on a Zone -
Bypassing DNS entry for SZ AP discovery
How to manually configure an SZ AP to connect to a desired SZ controller when DNS server on network specified a different controller.