Knowledge Base Articles
Browse Results: ZoneFlex Outdoor > Firmware
-
This Article provides the list of AP's which support IoT Gateway Module.
-
How to configure AP Ethernet port settings
Enabled ports can be used as Trunk port, Access port, or General port. This article provides definitions and application details. -
How to retrieve AP support info with Client details and RF Athstats?
The AP support info file/text/log provides rolling 2 minute RF sample and currently connected client statistics. This article explains where and how to collect this info from ZD, SZ, Cloud, or Solo APs. -
AP firmware Update via CLI fails with fw(5189) : Unknown error
This artcile describes a type of error seen when performing an AP firmware update via CLI -
Uploading and installing AP Patch after testing with private AP build
Customer was testing a private AP build on a few AP's in a Zone and subsequently needed to upload an AP Patch with fix -
APs with Static IP fail to connect to SZ 5.2 Dual-Stack Zones (TSB-2020-008)
APs with Static IP addresses can fail to connect to SZ 5.2 Dual-Stack Zones. -
APs with Solo Image 114.0.x SZ SSH connection failure (TSB-2020-007)
This Article describes a condition of AP joining issues with SmartZone from Solo AP image 114.0.x.x. -
How to find MD5CheckSum value of AP Firmware image
Where to find MD5CheckSum Value of AP Image -
Upgrade to an intermediate version of code before upgrading to the latest fully secure versions of AP code.
-
How to update solo AP firmware using Smart Zone controller and https protocol ?
In certain cases, user may wish to manually update the AP to a version already loaded on the Smart Zone controller. The following work around will allow AP with solo image 110+ and Smart zone 5.0+ to manually update an AP to match the destination Smart Zone AP version then join the controller.