Knowledge Base Articles

Browse Results: T710

• Accessory Guide incorrectly indicates wrong mounting bracket as suitable for T710 and T710s

  An Accessory Guide (version 16-12-A) incorrectly indicated SKU# 902-0182-0003 mounting bracket as suitable for T710 and T710s. The correct mounting bracket should be SKU# 902-0125-0000
  https://cloudsupport.ruckuswireless.com/answers/000008153
  Updated: "2021-05-03 Votes: 1

• How much PoE output power can the T710 provide when connected to 220v AC? 

  The T710 can provide up to 802.3at (25.5 W) to the powered device via the PoE Out connection, when the T710 is connected to 220v AC.
  https://cloudsupport.ruckuswireless.com/answers/000008518
  Updated: "2018-10-26 Votes: 0

• LACP configuration 

  Configure LACP using AP CLI
  https://cloudsupport.ruckuswireless.com/answers/000009914
  Updated: "2019-10-28 Votes: 0

• IoT Device Regulations (TSB 2019-008) 

  This Bulletin describes the changes available on the Ruckus standalone AP Image 114.0.0.0.1294, which was created because of California Senate Bill 327 (CA SB-327) which goes into effect January 1, 2020.
  https://cloudsupport.ruckuswireless.com/answers/000010008
  Updated: "2020-01-09 Votes: 0

• Is the AP CLI command "dfs-high-density wifi1" persistent? 

  Is the command "set dfs-high-density wifi1 x" still there after a reboot of the AP?
  https://cloudsupport.ruckuswireless.com/answers/000012034
  Updated: "2022-01-12 Votes: 0

• Does the AP CLI command "dfs-high-density wifi1" survive an AP upgrade? 

  Will the configuration setting dfs-high-density still be there after a firmware upgrade?
  https://cloudsupport.ruckuswireless.com/answers/000012035
  Updated: "2022-01-12 Votes: 0