What are some of the best practices for VoIP deployments using Ruckus Wireless devices?


This article lists some of the configuration changes that can be made on the ZD/APs as well as on the VoIP handsets to ensure best call quality.


What are some of the best practices for VoIP deployments using Ruckus Wireless devices?

Customer Environment

ZD (or SZ) managed APs providing wireless service to VoIP handset

Root Cause

Mismatch between VoWLAN device and WLAN settings can result in bad call quality, roaming difficulty, dropped calls.

Troubleshooting Steps

Evaluate each VoWLAN device during Site Survey if possible.  Compare device design guide to ZD/SZ WLAN settings.


Here are some of the recommended configurations to consider that are specific to ZD and APs 
1. Dedicated SSID for voice clients. Use a dedicated VLAN as well.
2. Tunnel traffic to ZD
3. Enable Call Admission Control (CAC)
4. DTIM value of 2 (this will ensure decent battery life without compromising call quality)
5. Enable OFDM-only
6. BSS minrate of 5.5 Mbps
7. Use particular channels only (e.g.: channels 1, 6, and 11 only)
8. Enable 802.11d
9. Increase background scan-interval to a higher value - 5 or 10 minutes
10. See if ChannelFly is appropriate for your environment. If this doesn't suit, switch to background scanning and increase the scan interval to a higher value as mentioned above.
11. Disable mesh
12. Avoid any additional load on the APs
13. Enable RTS/CTS
14. Eliminate rogue APs and mobile hotspots

Please note that not all these settings may be appropriate for your deployment and VoIP handset you are using. Use only the ones that are recommended by your VoIP handset maker.
Here are some of the configuration settings to consider that are specific to a VoIP handset: 
1. Enable voice DSCP marking
2. Operate at max transmit power
3. Prefer 5 GHz frequency mode if available. This might require more number of APs. So site survey is the key.
4. Disable DHCP request on roaming if there is a single VLAN for all voice clients
5. Control roaming if the device permits fine tuning
6. QoS preference. Some handset makers recommend using Continuously Awake Mode (CAM). Some may recommend legacy power save.

Find the latest VoIP design best practices for SmartZone 3.6+ at This Link.

Article Number:

August 18, 2020 04:28 AM (over 2 years ago)

Performance, Configuration, Installation, Troubleshooting, ZoneDirector, SmartCell Gateway, virtual SmartCell Gateway


This article is:
not helpful

Working...Please wait

This is here to prevent you from accidentally submitting twice.

The page will automatically refresh.