WebUI problem after upgrading to 9.5.0

Question

WebUI problem after upgrading to 9.5.0

Customer Environment

ZD

Workaround

There is a CLI command that can typically reset the WebUI, without having
had to downgrade your firmware again, that we’d like to suggest before going thru the
software install/reboot process. Let me provide this for reference.

SSH to your ZD, login with your admin credentials and you can reset your certificate thru
the command interface. This will restart your ZoneDirector after the certificate is reset.

ruckus> en
ruckus# config
ruckus (config)# certificate
ruckus (config-certificate)# restore
ZoneDirector will restart now to apply the changes in the certificate settings.
[ and you lose your connection ]

Run a continuous ping from a DOS command prompt window, until your ZoneDirector
replies again, when you can try the WebGUI once more.

Resolution

We have seen a WebUI access issue after upgrade for a very few customers who went straight 
from version 9.4.0.0.110 to version 9.5.0.0.156, without going thru the 9.4.2.0.29 MR first. 

Symptoms:

You will see a Secure Connection Failed message like the below

secure connection failed error after 9.5 upgrade from 9.4.0

 


Ping and SSH access are unaffected, the operation of the wireless network is unaffected.

You can avoid the problem if you go to our Support Site Downloads page, and get 9.4.2.0.29 firmware for your ZD.

https://support.ruckuswireless.com/user-full-ac…

To upgrade, start at Administer/Backup and save a copy of the current config.
You might wish to add “9400110” to the filename afterwards. Then from Administer/
Upgrade, you browse the 9.4.2.0.29 file just downloaded, and when prompted to do a
backup, you can skip and click Upgrade to continue.

Run a continuous ping to your ZD’s IP address, and after it’s uploaded the whole image
it will reboot, and you’ll see some pings miss (if you’re not able to see the status LED go
from flashing red to green after rebooted and fully back up). A couple minutes later you
should be redirected, else click the URL to get the ZD login.

From Monitor/Access Points, you can watch as the APs go from upgrading firmware 
to disconnected when they reboot, to provisioning and finally Connected states again,
when you can repeat the process for 9.5.0.0.156.

WORKROUND:

If you have already done the upgrade, and experienced the problem...

There is a CLI command that can typically reset the WebUI, without having 
had to downgrade your firmware again, that we’d like to suggest before going thru the 
software install/reboot process.

SSH to your ZD, login with your admin credentials and you can reset your certificate thru 
the command interface. This will restart your ZoneDirector after the certificate is reset. 


ruckus> en 
ruckus# config 
ruckus (config)# certificate 
ruckus (config-certificate)# restore 
ZoneDirector will restart now to apply the changes in the certificate settings. 
[ and you lose your connection ] 


Run a continuous ping from a DOS command prompt window, until your ZoneDirector 
replies again, when you can try the WebGUI once more.

Article Number:
000001346

Updated:
April 30, 2021 02:07 AM (about 1 year ago)

Tags:
Troubleshooting, Known Issues and Workarounds, ZoneDirector

Votes:
3

This article is:
helpful
not helpful

Working...Please wait

This is here to prevent you from accidentally submitting twice.

The page will automatically refresh.